Abstract

The objective of any pivot irrigation system is to ensure uniformity of application of water which can be achieved when responsible factors such as pressure, drop tube lengths, nozzle size etc. are adequately designed. This indoor experiment conducted in a 44m2 laboratory facility tends to evaluate the extent of the influence of some sprinkler design parameters on the performance of a low pressure single pivot sprinkler spay unit. The parameters considered are; pressures of 9,12, 15 and 19Psi, nozzle sizes of 4.17, 5.56, 6.95 and 8.14 mm and drop tube lengths of 1, 1.2 and 1.5m. In this experiment an inverted U-shaped frame designed to support a spray sprinkler at different heights was used. The hydraulic installation with manual throttle valves for controlling water distribution was used to supply pressurized water to the spray model sprinkler. A number of 64 graduated catch-cans with 0.16 m diameter and 0.2m height were used. The cans were arranged in eight radial legs with a distance of 1m apart. The system was run for one hour then the caught volumes were measured manually using a graduated cylinder with a capacity of 500 mL. The catch-cans data were used to determine uniformity coefficients. Line graphs were used to show relationships between the parameters measured. The experiment shows that there is strong relationship between the parameters considered. It indicated that the coefficient of uniformity (CU) and distribution uniformity of lower quarter DUlq increases with increase in nozzle size and pressure. It also shows that the largest nozzle size and pressure within the limits of this experiment gave the best CU and (DUlq) values of 96% and 90% at 1.5m height. Lager nozzle sizes with lower pressure reduces the CU and DUlq values. It is concluded from this experiment that though pressure, nozzle size and height of application influences the uniformity of application, larger nozzle sizes accompanied by higher pressure and height of application resulted in good uniformity of application. It is therefore imperative that while operating Pivot Sprinkler systems, careful selection of nozzle diameters, operating pressure and drop tube heights, sprinkler can be used to apply the ideal amount of irrigation water needed to refill the crop root zone that can neither cause runoff nor harm the crop and also provide the best uniformity possible under the prevailing wind and management conditions.

Keywords

heights, irrigation uniformity, nozzle size, pressure, sprinkler irrigation system uniformity coefficients